Sony LPM-770BP Operating Instructions Manual page 46

CHROMA
Press the button to display the adjustment screen and
adjust the color intensity. Press again to hide the
adjustment screen. However, the color intensity remains
adjustable. Turn the menu selection control right to
increase the intensity and turn left to decrease it.
PHASE
Press the button to display the adjustment screen and
adjust the color tones. Press again to hide the adjustment
screen. However, the color tones remain adjustable.
Turn the menu selection control right to increase the
green tone and turn left to increase the purple tone.
(This function can only be used with NTSC.)
APERTURE
Press the button to display the adjustment screen and
adjust the picture sharpness. Press again to hide the
adjustment screen. However, the picture sharpness
remains adjustable. Turn the menu selection control
right to make the picture sharper and turn left to make
the picture softer.
VOLUME
Press the button to display the adjustment screen and
adjust the volume. Press again to hide the adjustment
screen. However, the volume remains adjustable. Turn
the menu selection control right to increase the volume
and turn left to decrease it.
PEAKING
Press the button to display peaking. When the button is
pressed again, the monitor switches automatically to
normal display. Set the peaking level in the PEAKING
LEVEL menu.
VLM (VIDEO LEVEL MARKER)
Press the button to display VLM. When the button is
pressed again, the monitor switches automatically to
normal display. Set the VLM level in the VLM SELECT
menu.
ASPECT
Press the button to set the aspect ratio of the picture, 4:3
or 16:9.
Note
The panel of the monitor is 15:9.
When the 16:9 signal is displayed, black bars appear in
the upper and lower positions of the display. This is not
a malfunction (see "Scan mode image" on page 20).
TWO PICTURE MODE
Press the button to display COMPOSITE 1 and
COMPOSITE 2 at the same time. When the button is
pressed again, the monitor switches automatically to
normal display. The LINE selected before entering two
picture mode is displayed.
20-GB
Adjustment Using the Menus
Note
The function can be operated when COMPOSITE 1 or
COMPOSITE 2 is selected. Press the button to display
the image from COMPOSITE 1 on the left when
COMPOSITE 1 is selected. Press the button to display
the image from COMPOSITE 2 on the left when
COMPOSITE 2 is selected.
When you press the button again, the monitor switches
back automatically to normal display.
COMPOSITE SELECT
Press the button to switch the display between
COMPOSITE 1 and COMPOSITE 2.
Note
The function can be operated when COMPOSITE 1 or
COMPOSITE 2 is selected.
SCAN
Press the button to change the scan size of the picture.
With every press of the button for the 4:3 display, the
picture switches in the sequence NORMAL scan t
OVER scan t NATIVE. With every press of the button
for the 16:9 display, the picture switches in the sequence
NORMAL scan t OVER scan t FULL screen t
NATIVE (see "Scan mode image" on page 20).
MONO
Press the button to display a monochrome picture. When
the buttons is pressed again, the monitor switches
automatically to color mode.
MARKER
Press the button to display the marker. Set the aspect
marker in the MARKER SETTING menu (see page 18).
Scan mode image
4
4 :3
640 × 480
4
640 × 480
16
3
9
16:9
800 × 450
16
3 9
800 × 450