Troubleshooting; Warranty - Farmcomp FARMEX HT-PRO Operating Instructions Manual

EN
is replaced. This signifies that the tester has re-initialized. The
last calibration and backlighting (on/off) status will be utilized.

5. TROUBLESHOOTING

1.Read this manual again. Carefully.
2.Clean probe tip and recalibrate tester.
3.If "LOBAT" is displayed, replace the battery with a new 9-volt
ALKALINE battery. Re-calibrate the tester.
IF SERVICE IS REQUIRED Contact your Farmex
reseller or Farmcomp .
IMPORTANT: Keep original invoice or other proof of purchase.
Proof of purchase is required to determine if service will be
performed within the warranty period at no charge.

6. WARRANTY

The HT-Pro moisture and temperature tester carries a one year
manufacturer warranty for materials and workmanship. The
warranty is valid for 12 months from the date of purchase on
the receipt. To claim the warranty, the customer should return
the defect product to the Manufacturer or reseller. The
warranty claim must be accompanied by the description of the
fault, copy of sales receipt and customer's contact information.
The Manufacturer service partner will repair or replace the
defect product and return it as soon as possible.
The liability of Farmcomp is limited to the price of the product in
maximum. The warranty does not cover any damage that is
caused by incorrect or careless use of the product, dropping the
product or damage that is caused by repairs that are carried out
by non-authorized personnel. Farmcomp does not accept any
responsibility for any direct, indirect or consequential damages
that are caused by the use of the product or the fact that the
product could not be used.
The battery is not covered by the warranty.
All information, illustrations and specifications in this manual are
based on the latest information available at the time of
publication. The right is reserved to make changes at any time
without notice.
8