Table of Contents
Advertisement
OPERATING
INSTRUCTIONS
FARMEX ™ HT-PRO
PORTABLE MOISTURE AND
TEMPERATURE TESTER
FOR BALED HAY
Thank you for choosing Farmex!
Please read this instructions carefully.
1.GENERAL OPERATING INSTRUCTIONS
1.1 Install battery. The 9-volt alkaline battery (included) must be
connected before the tester will work. Remove the battery door
on the back of the handle and snap the leads onto the battery.
NOTE:
After installing the battery, your tester will display
"88.8"briefly upon pressing any of the buttons for the first
time. This is normal and indicates that the tester is initializing
NOTE:
"LOBAT" will appear in the display, if the battery is
running low and needs replacing.
NOTE:
The battery needs to be ALKALINE.
1.2 There is no ON/OFF switch. Press any of the buttons and
the HT-PRO™ will turn itself on.
NOTE:
Upon pressing a button, there is a short delay until a
reading is displayed.
1.3. To test moisture, press the button above the "water drop".
You will see the water content of the sample in per cent of
weight.
1.4 To test temperature, press the button above the
"Thermometer" symbol. You will see two readings, first the
temperature in Fahrenheit and then the temperature in
EN
3
Advertisement
Table of Contents
Need help?
Do you have a question about the FARMEX HT-PRO and is the answer not in the manual?
Questions and answers