Table of Contents
Advertisement
Recorder
1. Plug USB hard drive to TAO 1pro USB 2.0 port.
2. Click record icon to start recording.
Note: If there is no USB flash drive inserted, the recording icon displays gray status.
Settings
Click [Setting] in Scroll Area to enter following interface to set Input Settings, Network, Bluetooth, UVC Control,
Fan Control, Stream Output, NDI Decoder, NDI Encoder, Display and About.
Input Settings: Input Signal, Input Format, Audio Sampling Rate, Signal Name, Brightness, Contrast,
Saturation, Hue and Sharpness.
Network: Set IP Address, Netmask and Gateway.
Bluetooth: ON/OFF.
camera.
UVC Control:
Adjust parameters of
Fan Control: Set
fan speed and fan mode.
Stream Output: Set display mode, resolution ,frame rate, bitrate.
NDI Decoder/Encoder: Same settings as previous parts shown.
Display:Set the brightness of the output, HDMI output resolution and display rotation.
About: Include device info, language setting, update setting and factory reset.
© Xiamen RGBlink Science & Technology Co., Ltd.
Ph: +86 592 5771197 |
Turn ON Bluetooth and choose the device to be connected to achieve control of PTZ
PTZ cameras connected to TAO 1pro.
support@rgblink.com
|
www.rgblink.com
10 / 14
Advertisement
Table of Contents
Need help?
Do you have a question about the TAO 1pro and is the answer not in the manual?
Questions and answers