R&S TSMA6B-BP Manual page 28

®
R&S TSMA6B-BP
To charge the batteries in-bay
1. Insert the batterie(s) in the correct way (charge indicator facing up).
2. Take care of the nut in the battery and the pin inside the battery bay (see
Chapter 8.2.2, "Hot swapping battery
Charging starts automatically when DC power is connected. For checking the
charging state, see
on page 23.
To charge the batteries with an external charger
1. Press the battery bay lid(s) and open it up.
2. Remove the batteries.
3. Connect the batteries with an external charger.
NOTE: For allowed charger types, see
on page 26.
4. To check, if the batteries are fully charged, refer to
the charge status of the individual
Manual 4900.9099.02 ─ 02
Chapter 6.4.2, "Rear panel LEDs in standalone
battery",
Maintenance, storage and disposal
exchange", on page 29).
"External charger for batteries"
Chapter 6.4.1, "Checking
on page 22.
Handling batteries
operation",
28