Rear Panel Leds In Standalone Operation - R&S TSMA6B-BP Manual

®
R&S TSMA6B-BP
Figure 6-2: LED segment display
3. You can read the charge state from the LED segment display.
When the batteries are charged, the LED of the LED segment display is blink-
ing.
4. Insert the battery in its bay (see
teries", on page 12).
6.4.2

Rear panel LEDs in standalone operation

The status of each battery is displayed separately. For details, see
No R&S TSMA6/6B is connected and R&S TSMA6/6B switched off.
In standalone mode, the battery charge status is only displayed when an external
DC power supply is connected. The charge in battery mode without connected
DC power supply can only be read directly from the battery (see
"Checking the charge status of the individual
Table 6-1: LED states in standalone operation
Color
---
green
green
Manual 4900.9099.02 ─ 02
Chapter 3.3, "Inserting and removing the bat-
LED state
OFF
BLINKING (2 Hz)
ON
Operating the battery pack
Monitoring the battery charge status
battery", on page 22).
Comment
Battery 1/2 not present or
external DC power not availa-
ble
Battery fully charged (100 %)
Battery charging in progress /
external DC power connected
Figure 4-2.
Chapter 6.4.1,
23