Wiring; Pin Assignment - Siemens SIMATIC ET 200SP Manual

Wiring

3.1

Pin assignment

The TM Count 1x24V is used with a BaseUnit of the A0 type.
The encoder signals, the digital input and output signals and the encoder supply are
connected to the BaseUnit of the technology module. The supply voltage feed on the light
BaseUnit BU...D of the associated potential group supplies the module and the digital
outputs, and generates the encoder supply voltage.
BaseUnit
The BaseUnit is not included in the scope of delivery of the module and must be ordered
separately.
For an overview of the BaseUnits to be used with the technology module, refer to the product
information on the documentation for the ET 200SP Distributed I/O System
(http://support.automation.siemens.com/WW/view/en/73021864).
You can find information about selecting a suitable BaseUnit in the ET 200SP Distributed I/O
System (http://support.automation.siemens.com/WW/view/en/58649293) system manual and
ET 200SP BaseUnits
(http://support.automation.siemens.com/WW/view/en/58532597/133300) device manual.
You can find information on wiring the BaseUnit, connecting cable shields, etc. in the
Connecting section of the ET 200SP Distributed I/O System
(http://support.automation.siemens.com/WW/view/en/58649293) system manual.
Technology Module TM Count 1x24V (6ES7138‑6AA00‑0BA0)
Manual, 10/2013, A5E33002339-AA
3
17