Saxby Lighting Triton Spike Instruction Manual

Fitting/Replacing the bulb: Max. 5W LED GU10
When changing a bulb, always switch off at the mains and allow the bulb to cool before handling.
Dispose of used bulbs carefully. Use a soft cloth to handle bulbs, avoid directly touching the
bulbs as this will shorten their life.
Do not exceed the wattage stated or use a different shape bulb from that indicated on the fitting.
Enure that the seal is correctly located and that the four screws are tightened after you
have changed the bulb.

Technical data

Supply
220-240V~, 50Hz
Voltage:
Bulb
Max. 5W LED GU10 (required)
Type:
Conformity with all relevant UKCA Directive requirements.
Conformity with all relevant EC Directive requirements.
The power supply is Double Insulated and does not require connection to an Earth circuit.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or local store for recycling advice.
This product is suitable for dimming.
This product is rated at IP65.
65
IP

Care and Safety

We recommend cleaning with a soft dry cloth. Do not use solvents or abrasive cleaners as these could damage the finish.
For your safety, always switch off the power supply before changing lightbulbs, or cleaning.
The LED's are protected by a plastic lens. The lens part must be replaced immediately should
it become cracked or damaged. This fitting must not be used without the plastic lens in place.
Replace Cracked Shade
V2 05/12/2021
UK Manufacturer: BH17 7BY
EU Manufacturer: Brilliant AG,
Brilliantstrasse 1, D-27442 Gnarrenburg
Instruction manual
Max. 5W
LED GU10
Triton Spike
99564
www.saxbylighting.com