Saxby Lighting OPAZ MV SPIKE Instruction Manual

Fitting/Replacing the bulb: Max. 7W LED GU10
When changing a bulb, always switch off at the mains and allow the bulb to cool before handling.
Dispose of used bulbs carefully. Use a soft cloth to handle bulbs, avoid directly touching the
bulbs as this will shorten their life.
Do not exceed the wattage stated or use a different shape bulb from that indicated on the fitting.
Enure that the seal is correctly located and that the four screws are tightened after you
have changed the bulb.
Technical data
Supply
220-240 V~, 50 Hz
Voltage:
Bulb
Max. 7W LED GU10 (required)
Type:
Conformity with all relevant UKCA Directive requirements.
Conformity with all relevant EC Directive requirements.
This is a Class 1 product and must be earthed.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or local store for recycling advice.
This product is suitable for dimming.
This product is rated at IP65.
65
IP
Care and Safety
We recommend cleaning with a soft dry cloth. Do not use solvents or abrasive cleaners as these could damage the finish.
For your safety, always switch off the power supply before changing lightbulbs, or cleaning.
This LED's are protected by a glass lens. The lens part must be replaced immediately should it
become cracked or damaged. This fitting must not be used without the glass lens in place.
Replace Cracked Shade
V5 10/05/2022
UK Manufacturer: BH17 7BY
EU Manufacturer: Brilliant AG,
Brilliantstrasse 1, D-27442 Gnarrenburg
Instruction manual
Max. 7W
LED GU10
OPAZ MV SPIKE
POLGU10, 90965
www.saxbylighting.com
POLGU10 90965