Reverb - Tascam DP-008 Owner's Manual

6 – Basic Recording
Set the track EQ using the
1 Press the key to open the
EQ
screen.
2 Set the track EQ (equalizer).
The track equalizer has the following
parameters.
Parameter
(track EQ
EQ-SWITCH
switch)
(high frequency
Hi -F
range)
(high range
Hi -G
gain)
(low frequency
Lo-F
range)
(low range
Lo-G
gain)
Use the (˙) and
F1
tracks.
Use the (§) and
F3
parameters.
Use the wheel to adjust the
DATA
parameters.
3 After making the track EQ settings,
press the key to return to the
HOME
Home Screen.
46
TASCAM DP-008
screen.
EQ SETTING
EQ SETTING
Setting value
ON/OFF
(Default: OFF)
1.7 kHz – 18 kHz
(Default: 5 kHz)
±12 dB
(Default: 0.0 dB)
32 Hz – 1.6 kHz
(Default: 350 Hz)
±12 dB
(Default: 0.0 dB)
(¥) keys to switch
F2
(¶) keys to select
F4
NOTE
When track EQ is ON for a track, the track is
shown on the Home Screen as in the illus-
tration below.
Track EQ is ON

Reverb

This unit has six types of reverb effects.
Adjust the level of the signal sent to the reverb
effect from each track by using their
knobs.
The signals are sent to the reverb effect after
track EQ (equalizer) is applied.
1 Press the
REVERB
screen.
REVERB SETTING
2 Adjust the reverb settings for the
following parameters.
Parameter
Hall 1/Hall 2/Room/
TYPE
Studio/Plate 1/Plate 2
(Default: Hall 1)
REVERB
key to open the
Setting value