Table of Contents
Advertisement
2 After setting the IN and OUT points,
press the record (º) and
the same time to enter auto punch in/out
mode.
3 Press the playback (Á) key.
Playback begins from two seconds before
the IN point, and the sound monitored
switches at the IN point from the track
playback sound and the input sound to just
the input sound. The
when between the IN and OUT points.
When playback reaches the OUT point,
the track playback sound and the input
sound becomes the monitored sound again,
and the
indicator stops blinking and
REC
turns off. Playback automatically stops one
second after the OUT point.
You can repeat rehearsal until you are
satisfied.
Using auto punch in/out to
record
When you are done rehearsing, you can use
auto punch in/out for recording.
1 While in auto punch in/out mode, press
and hold the record (º) key, and press
the playback (Á) key.
In the same way as during rehearsal,
playback begins from two seconds before
the IN point. Recording occurs and the
record indicator lights between the IN and
7 – Recorder Functions
keys at
IN/OUT
indicator blinks
REC
OUT points.
2 One second after reaching the OUT
point, the recorder automatically stops,
auto punch in/out mode is exited and the
transport locates to two seconds before
the IN point.
NOTE
•
Auto punch in/out mode cannot be
entered during repeat mode or if no REC
key has been pushed.
•
Auto punch in/out can be undone.
57
TASCAM DP-008
Advertisement
Table of Contents
