Table of Contents
Advertisement
3 – Names and Functions of Parts
Rear panel
FOOT SWITCH jack
z
You can use a foot switch to punch in and
out (start and stop recording).
INPUT B jack (1/4" phone jack)
x
Use this as the input source by setting
INPUT B to external input ("
") on the
Input
INPUT SETTING
You can use this jack for a line level or
mic level signal (unbalanced connection).
INPUT A jack (1/4" phone jack)
c
Use this as the input source by setting
INPUT A to
Ext. Input
on the
INPUT SETTING
use this jack for a guitar/line level or mic
level signal (unbalanced connection).
Set the
MIC/LINE–GUITAR
according to the input source.
v
MIC/LINE-GUITAR switch
Set this switch to match the input signal
to the
jack on the rear panel. For
INPUT A
mic or line signals, set it to
For electric guitars and basses that are
connected directly, set it to
INPUT A/INPUT B jacks (XLR jacks)
b
Condenser microphones that require
phantom power can receive it when
they are connected to these jacks. (See
"Phantom Power" on page 41.)
(Pin assignments—1: ground, 2: hot, 3:
cold)
If devices are connected to both the
XLR and the 1/4" phone jacks, the 1/4"
phone jack is given precedence (the XLR
connection is disabled).
Ext.
screen.
(external input)
screen. You can
switch
.
MIC/LINE
.
GUITAR
LINE OUT jacks
n
Use these to connect a monitoring system
(powered speakers or an amplifier with
speakers).
m
PHONES jack
Connect headphones (with a stereo mini-
plug connector) to this jack.
VOLUME dial
,
Use this to adjust the volume output from
the
connector.
PHONES
27
TASCAM DP-008
Advertisement
Table of Contents
