Table of Contents
Advertisement
Dubbing/Importing
Dubbing Still Images from
the HDD
Still images stored in the internal HDD can be dubbed to a
BD-RE or an SD card as follows.
Memo:
• Only "JPEG" still image format is supported.
For more details, refer to "Dubbing the picture data from the
HDD" (A page 24) .
Before dubbing
o
• Dubbing to a disc
Set the BD-RE for dubbing on the disc tray
• Dubbing to an SD card
Insert the SD card to be dubbed into the [SD SLOT]
Dubbing still images
o
1 Press the [DUBBING] button on the remote
control unit
• The Dubbing menu screen appears.
2 On this screen, select "DISC/SDiPICTURE"
3 Select the media to dub to from the media
selection screen
• A checkmark will be added to the selected media.
42
4 Select "NEXT", and press the [OK] button
Memo:
• A message appears on the monitor when dubbing cannot
be performed in the following cases. When this occurs,
replace the disc or SD card with one that is usable.
• When an incompatible disc or SD card is set
• When there is insufficient space on the set disc or SD
card
• When an unformatted disc or SD card is set
For details, refer to "Formatting a disc" (A page 25) or
"Formatting an SD Card" (A page 27) .
5 Select the still images to dub, and press the
[MARK] button
• Pressing the [MARK] button adds a check mark to the
selected image.
All still images with a check mark are dubbed.
Memo:
• To clear the check mark, select the corresponding still
image, and press the [MARK] button.
• Pressing the [OPTION] button displays a pop-up menu.
The pop-up menu enables you to perform the following
operations.
BACK
: Exits the pop-menu and returns to the
initial screen.
SELECT ALL
: Selects all still images within the same
group.
DESELECT ALL : Clears the selection of all still images
within the same group.
Note:
• A message appears if the selected still images do not fit
into the disc. Check mark cannot be added to a still image if
there is insufficient space on the disc.
Advertisement
Table of Contents
