HOGERT HT1E605 User Manual page 7

This device is not intended for use by persons with reduced physical, sensory or mental capabilities or lack of experience and/or
skills, unless such persons are accompanied and supervised by persons responsible for their safety or have received precise instruc-
tions for the device usage and understand the risks involved. Children may only use this device if they are over 8 years old and under
the supervision of a person responsible for their safety or if they have received instructions for use of this device and understand the
risks involved. Children cannot play with this device.
Safety Information
Smart Multimeter HT1E605 was designed and manufactured in accordance with the safety requirements for an electronic measuring
instrument and a hand-held digital multimeter in accordance with the international safety standard for electricians EN 61010. It's
compatible with 600V (CATIII) EN 61010 and contamination level 2. Due to assure safety usage of device please refer to user's manual:
• To avoid possible electrical shock, fire or personal injury, please read all safety information product only as specified, or the protec-
tion supplied by the product can be compromised.
• Examine the case before you use the product. Look for cracks or missing plastic. Carefully look at the insulation around the
terminals.
• The measurement must be made within the allowable measuring range.
• Do not use the product around explosive gas, vapor, or in damp or wet environments.
• When the voltage to be measured exceeds 36V DC or 25V AC the operator shall be
careful enough to avoid electric shock.
• Misuse of mode or range can lead to hazards, be cautious."OL" will be shown on the display when the input is out of range.
• Low level of a battery will result in incorrect readings. Change the batteries when battery
level is low. Do not make measurements when the battery door is not properly placed.
SAFETY SYMBOLS:
High voltage can occur. .
Alternating Current AC
Direct Current DC
Direct or alternating
current DC/AC
3. DEVICE AND FUNCTIONS DESCRIPTION
Turn on and off buttons: Short press this button
to turn on, And into the voltage/resistance automatic recognition mode .(Can be directly measured voltage or resistance.)
hold down this button for about 2 seconds and then turn off
Push once to hold the current reading on the display;
Push for more than 2 seconds to turn
on the flashlight backlight. And long-
push again to turn off.
In capacitance mode, it can clean the
reading on the screen.
Function switch button: Short press the button once and Choose (NCV) or (CAP) or (A),Select one function at a time.
Long press this button for approximately 2 seconds to exit the function mode and enter the voltage/resistance automatic
recognition mode.
4. Measurements
Adres producenta/ Adresse des Herstellers/ Manufacturer's Address/ Адрес производителя
GTV Poland Sp. z o.o. Sp. k., ul. Przejazdowa 21, 05-800 Pruszków
Ground
Important safety
information.
Double insulation
Fuse
7