Error Detection - Strend Pro K-408 Instruction Manual

EN
Dust cleaning:
- Before you contact our service center, please check the following:
PROBLEM
Take down the filter.
Take the new filter. Aim the assembly position and pressure to the bottom
Iightly.
To fix the filter cover convex toward the filter, aim at fixed crew and
through the centre hole, fixed cover press the filter tightly.
Aim the fixed nut and through the screw of the fixed cover, then screw
clockwise tightly.
To loosen the two buckles
Hold the handle and take out the head
Turn the head and suspended above the trash, clean the dust on filter
by brush carefully, if necessary, can hit the mesh out of the filter, to
clean the dust surface of the filter.
If necessary, take down the filter, and clean the filter from inside to
outside by clear water, the filter can not be use again until it's dry.
Fall the dust into trash can and clean the dust on the inner wall of the
barrel. If necessary, can use the wet cloth to wipe the surface of barrel.
After clean up the dust, fix the filter back according to the replacement
of filter instruction. Then fix the head onto the tank, lock the bucket,
finally fix the aluminum tube with hook onto the button of tank.

ERROR DETECTION

POSSIBLE REASON ADVICE