Operation; Maintenance And Cleaning - Strend Pro K-408 Instruction Manual

EN
- Check the vacuum cleaner and suction hose during operation. If you detect overheating, immediately
switch off the vacuum cleaner and disconnect the power cord from the socket. Remove the dirt from the
vacuum cleaner and allow it to cool in exterior under the supervision.
- When the appliance is not in use it should be unplugged and stored in a dry, protected place out of the
reach of children. Do not store on flammable substrates or polymer substrates, carpet or vinyl tiles.
- Do not use for the separation of health-hazardous dusts (dust classes L, M, H).
- Do not vacuum soot.
- Do not vacuum any hot, burning or glowing objects.
- Do not vacuum any objects that are hotter than 40 °C.
- Do not vacuum any flammable substances.
- Check that the plug is disconnected from the mains.
- Unfasten the lock tabs on the vacuum base.
- Lift the top off. Place the top over the base and fasten with the lock tabs.
- Connect the aluminum tube with plastic hose, fit the plastic hose to the tank at the suction hole.
SWITCH ON/OFF:
- Insert the plug into a correctly installed mains socket.
- To switch on the ash vacuum cleaner, press the switch to „I" position.
- To switch off the ash vacuum cleaner, press the switch to „0" position.
- Before carrying out any maintenance, switch off the appliance and pull the electrical plug out of the
socket.
- Clean the surface with a soft, dry cloth.
- Never use water and detergents, such as rubbish, gasoline or thinner to clean the appliance.
- After cleaning, hold the aluminum tube and plastic hose in a vertical position so that any loose ash falls
into the vacuum cleaner container.
Empty the container:
Once the container is full remove the suction hose and unfasten the cover with the lock tabs, empty the
container out onto a suitable piece of packaging and dispose of it.
Replacement of filter:

OPERATION

MAINTENANCE AND CLEANING

Screw out the nut of filter anti-clockwise.
Remove the fixed covet from filter.