Blower Installation; External Blower Programming Procedure - Best HBC1 Series Installation Use & Care Instructions

BLOWER INSTALLATION

This hood is compatible with the following blowers. Select a blower model among these: internal blower - PM6 or PM12,
exterior blower - EB9 or EB15, in-line blower - ILB6, ILB9 or ILB11. Refer to the installation instructions provided with
the blower for more details.
NOTE: Rough-in plate included with exterior blower kit is not needed for ceiling hood application.

EXTERNAL BLOWER PROGRAMMING PROCEDURE

This range hood is designed to work with several different blower models. Before using the hood, the control must first
be programmed for your blower model in order to achieve proper operating speed:
1. Find the SETUP number that corresponds to the blower model that is installed with your range hood.
SETUP 1
ILB6
NOTE: If no button is touched for more than 3 seconds while the hood is in programming mode, the hood will exit
the programming mode without saving the changes.
2. There must be power to the hood but the blower and lights must be turned off.
3. To change the setup, press and hold BLOWER and LIGHT buttons simultaneously for 6 seconds and release, then:
To set the range hood at SETUP 1, press BLOWER button until button 1 alone lights up.
To set the range hood at SETUP 2, press BLOWER button until both buttons 1 and 2 light up.
4. Press DELAY OFF button to save and leave programming mode.
5. If needed, verify which setting the hood is currently in. To do so:
Press and hold BLOWER and LIGHT buttons simultaneously for 6 seconds and release. Different
combinations of SPEED buttons (1 to 4) will turn ON for 3 seconds, depending on the setting.
NOTE: To reset to default, press and hold BLOWER and LIGHT buttons simultaneously for 6 seconds and release.
Different combinations of SPEED buttons (1 to 4) will turn ON for 3 seconds. Press and hold LIGHT button
for 3 seconds then SPEED buttons will flash 3 times. Setting is back to original status.
9
SETUP 2
EB15
ILB9
If set at SETUP 3, SPEED buttons 1, 2, 3 and 4 will light up.
If set at SETUP 2, SPEED buttons 1 and 2 will light up.
If set at SETUP 1, SPEED button 1 will light up.
SETUP 3 (by default)
EB9
ILB11