Motion Set - Swann DVR4-Alert SW242-DAL User Manual

5.14 Motion Set

MOTION SET
MOTION RECORD TIME:
MOTION ALARM TIME:
MOTION SET
PRESS (UP, DOWN), ENTER
(SELECT)
PRESS (MENU)
MOTION SET:
MOTION DETECTION SET
>CHANNEL 1 SENSITIVITY
CHANNEL 2 SENSITIVITY
CHANNEL 3 SENSITIVITY
CHANNEL 4 SENSITIVITY
CHANNEL 1 AREA SET
CHANNEL 2 AREA SET
CHANNEL 3 AREA SET
CHANNEL 4 AREA SET
PRESS (UP, DOWN), ENTER
(SELECT)
PRESS (MENU)
AREA SET:
Use [ Up] and [ Down] button to select the channel you want to modify and
press [ SEL] button to enter the sensitive area of each camera. The picture of the
selected channel is divided into 144(12*12) blocks, press [REW] to move left,
press [FWD] to move right, press[ Up] and [ Down] to move the cursor up and
down, press [ SEL] to set the highlighted block active or disabled.
When the block is transparent, it's active or set to detect motion. When the
block is covered by a shadow, it is not active and motion will NOT be detected.
Make sure Record Schedule is set to Motion for the times required.
10
OFF
TO EXIT
4
4
4
4
TO EXIT
MOTION RECORD TIME:
This number indicates how many
seconds the motion detection recording
lasts after the DVR has detected motion.
MOTION ALARM TIME:
This number indicates how many
seconds the buzzer/alarm inside the DVR
will sound after the DVR has detected
motion.
CONT: Continuous alarm until press any
key is pressed when motion detected.
OFF: No alarm
SENSITIVITY:
Use [ Up] and [ Down] button to
highlight the channel you want to modify
and press [ SEL] to adjust sensitivity of
motion detection on each channel.
High (1----------9, OFF) Low
When "OFF", the channel will not
detect motion or trigger motion recording.
- 11 -
User Manual