Thermo Scientific SAM12 Manual page 83

Issue: 1.0
Interfaces
Thermo Fisher Scientific
• Cal Check Data Retention (months)
• Event Log Data Retention (months)
Select System|Interfaces to
configure an interface to another
system
Note that the example given in this description is of a
connection to a ViewPoint MultiServer. Other interfaces are
possible and the parameters described below may vary
according to the interface selected. Please contact Thermo
Fisher Scientific regarding your specific interface requirements.
Select the Configure Interface
button to view the parameters:
Description of options:
Field Name Description
Enable Tick this option to enable the interface to work with
the SAM12.
Instrument ID Enter the Instrument ID using the numerical field
Report Interval (s) This is the interval in seconds, that the system
checks the connection to the interface.
Primary Interface Tick this option to use the Primary details to
Enable connect to the interface (see below).
Primary IP Address This is the IP address for connection to the
interface.
Primary TCP Port This is the TCP Port for connection to the interface.
Secondary Interface Use the pre-defined window to select a option from
Mode one of the following:
Disabled – select this option to not use the
Secondary details (see below)
Fallback – select this option for the Secondary
details to be used if the Primary connection fails
Enabled – select this option for the Secondary
details to be used
Secondary IP Address This is the IP address for connection to the
interface.
Operating Instructions
SAM12 User Manual 5-43