Quick Start Guide; Shared Software Settings - Ossila Solar Cell I-V Test System User Manual

Solar Cell I-V Test System (Manual)
Figure 9.3. Ossila Solar Cell I-V software: The Stabilised Current tab.
9.2

Quick Start Guide

1. Start the Ossila Solar Cell I-V software. The window shown in Figure 9.1will open.
2. Choose a measurement type as described in Section 9.1.
3. Place your sample in the device holder.
4. Place the device holder beneath your solar simulator.
5. Set the appropriate settings in the software (explained in more detail in Sections 9.4 - 9.8).
I. Set 'Pixel Switching' to 'Manual'.
6. Open the shutter of your solar simulator.
7. Click the 'Measure' button.
I. You will be prompted to switch to the first pixel to measure.
II. For each pixel, measurements are performed using the chosen measurement
settings.
III. This process is repeated until all pixels have been measured.
8. If automatic saving is turned on, the measurement data and settings will then be saved.
9.3

Shared Software Settings

The settings in these sections are shared between all measurement types.
Ossila.com 13
User Manual
Ossila Limited © 2022