Quick Start Guide - Ossila T2003 User Manual

Solar Cell I-V Test System
Figure 9.3. Ossila Solar Cell I-V software: The Stabilised Current tab.
9.2

Quick Start Guide

1. Start the Ossila Solar Cell I-V software. The window shown in Figure 9.1 will open.
2. Choose a measurement type as described in Section 9.1.
3. Place your sample in the device holder.
4. Place the device holder beneath your solar simulator.
5. Set the appropriate settings in the software (explained in more detail in Sections 9.4 - 9.8).
6. Open the shutter of your solar simulator.
7. Click the 'Measure' button.
I. For each pixel, measurements are performed using the chosen measurement
settings.
II. This process is repeated until all pixels have been measured.
8. If automatic saving is turned on, the measurement data and settings will then be saved.
www.ossila.com 14
User Manual
Ossila Limited © 2023