Electrical Connection; Preparation; What To Do For Energy Saving - Beko 978590EI User Manual

4.1 Electrical Connection

WARNING: Do not use extension or
multi sockets in power connection.
WARNING: Damaged power cable
must be replaced by Authorized Ser-
vice.

5 Preparation

What to do for energy saving

Read the "Safety Instructions" sec-
tion first.
• This refrigerating appliance is not intended
to be used as a built in appliance.
• Do not keep the refrigerator doors open
for long periods.
• Do not place hot food or beverages into
the refrigerator.
5.1 What To Do For Energy Saving
• Do not overfill the refrigerator; blocking the
internal air flow will reduce cooling capa-
city.
• Depending on the product's features; de-
frosting frozen foods in the cooler com-
partment will ensure both energy saving
and preserve food quality.
• Food shall be stored using the drawers in
the cooler compartment in order to ensure
energy saving and protect food in better
conditions.
• Make sure the foods are not in contact
with the cooler compartment temperature
sensor shown below.
• Our firm will not assume responsibility for
any damages due to usage without earth-
ing and power connection in compliance
with national regulations.
• The power cable plug must be easily ac-
cessible after installation.
Hot surface warning!
The side walls of your product are
equipped with cooler pipes to en-
hance the cooling system. High
pressure fluid may flow through
these surfaces, and cause hot sur-
faces on the side walls. This is nor-
mal and it does not require servicing.
Be careful when you contact these
areas.
• Since hot and humid air will not directly
penetrate into your product when the
doors are not opened, your product will
optimize itself in conditions sufficient to
protect your food. Under these circum-
stances, functions and components such
as compressor, fan, heater, defrost, light-
ing, display and so on will operate accord-
ing to the needs by consuming minimum
energy.
• In case that multiple options are present,
glass shelves must be placed so that the
air outlets at the rear wall are not blocked
and preferably, in a way that air outlets re-
EN / 47
TR
EN