Alignment - Sub-Zero Classic Series Installation Manual

Installation

Alignment

LEVELING
Once the unit is in position, turn the front leveling legs
clockwise to adjust the height. The rear height adjustment
can be made from the front of the roller base. Using a 3/8"
socket, turn the 3/8" hex bolt clockwise to raise the unit or
counterclockwise to lower. Use the lowest torque setting
when using a power drill. Do not turn the rear leveling legs
by hand. Refer to the illustration below.
When the unit is properly leveled, door and drawer adjust-
ments are less likely to be necessary.
IMPORTANT NOTE: Level the unit to the floor, not the sur-
rounding cabinetry. This could affect the operation of the
unit, such as door closing.
WARNING
To reduce the possibility of the unit tipping forward,
the front leveling legs must be in contact with the
floor.
FRONT
LEVELING LEG
REAR
ADJUSTMENT
Leveling
16 | Sub-Zero Customer Care 800.222.7820
DOOR ADJUSTMENT
Side-by-side and over-and-under doors are adjustable in
and out, and side to side tilt. Side-by-side doors only are
adjustable up and down and the handle sides are adjust-
able in and out. To adjust the handle side, rotate the
adjustable door bumper. Refer to the illustration below.
ADJUSTABLE
DOOR BUMPER
Adjustable door bumper