Table of Contents
Advertisement
2.2 SHIPMENT AND TRANSIT
The freezer has been assembled, operated and inspected
at the factory. Upon arrival at the final destination, the entire
freezer must be checked for any damage which may have
occurred during transit.
With the method of packaging used, the freezer should
arrive in excellent condition. THE CARRIER IS RESPON-
SIBLE FOR ALL DAMAGE IN TRANSIT, WHETHER VIS-
IBLE OR CONCEALED. Do not pay the freight bill until the
freezer has been checked for damage. Have the carrier note
any visible damage on the freight bill. If concealed damage
and/or shortage is found later, advise the carrier within 10
days and request inspection. The customer must place
claim for damages and/or shortages in shipment with the
carrier. Stoelting, Inc. cannot make any claims against the
carrier.
2.3 FREEZER INSTALLATION
Installation of the freezer involves moving the freezer close
to its permanent location, removing all crating, setting in
place, assembling parts, and cleaning.
A.
Uncrate the freezer.
B.
Lift freezer and screw on legs.
B.
Accurate leveling is necessary for correct drainage
of freezer barrel and to insure correct overrun.
Place a bubble level on top of the freezer at each
corner to check for level condition. If adjustment is
necessary, level the freezer by turning the bottom
part of each leg in or out.
C.
The freezer is equipped with an air cooled condenser
and requires correct ventilation. The bottom of the
freezer is the air intake and the sides are discharge.
Both sides must have 3" clearance.
CAUTION
Failure to provide adequate ventilation will void war-
ranty.
D.
Make sure the switch is in the OFF (middle)
position.
E.
Install drip tray support, drip tray, drip tray grid, and
drain tray.
F.
Connect the power cord to the proper power
supply. The plug is designed for 115 volt/20 amp
duty. Check the nameplate on your freezer for
proper supply. The unit must be connected to a
properly grounded receptacle. The electrical cord
furnished as part of the freezer has a three prong
grounding type plug. The use of an extension cord
is not recommended, if necessary use one with a
size 12 gauge or heavier with ground wire. Do not
use an adapter to bypass grounding requirement.
(Refer to Figure 2-2)
Figure 2-2 Electrical Plug
Do not alter or deform electrical plug in any way.
Altering the plug to fit into an outlet of different con-
figuration may cause fire, risk of electrical shock,
product damage and will void warranty.
4
WARNING
Advertisement
Table of Contents
