Advertisement
Echoflex Installation Guide
Photo & CCT Sensors
Tests and Settings
Use the [Teach] button and color LEDs to navigate the Tests and Settings
menu. Remove the cover to access the [Teach] button located beside the
battery clip. The LEDs display through the front lens.
Note:
cannot access the LED blink menu, install a good battery. See
Battery Power on page 3
Light Level Test
•
Range Confirmation
•
Rapid Response Test
•
EEP Select
•
The menu times out after two minutes of inactivity.
Light Level Test
The Light Level Test quantifies the amount of energy produced by the
solar cells and confirms a good installation location.
1. Press and hold the [Teach] button until the green LED is displayed.
Release the button to enter the menu and display the first item, the
blinking green LED.
2. Press and hold the [Teach] button again until the green LED stops
blinking. The green LED then repeats a number of blinks according to
the detected light level. The sensor reevaluates the light level every
two seconds.
Blinks
0
1
2
3
4
5
The test repeats every two seconds and runs for 100 seconds. To exit
before the time-out, press and hold the [Teach] button for 10 seconds.
Photo & CCT Sensors
A battery is required to run tests or change settings. If you
(green LED)
(blue LED)
(red LED)
(blue and red LEDs)
Ambient Light
Lux (Footcandles)
< 40 (< 3.7)
40–100 (3.7–9.3)
100–200 (9.3–18.6)
200–400 (18.6–37.2)
400–1000 (37.2–92.9)
> 1000 (> 92.9)
for installation instructions.
Time to Fully Charge
Non-operational
Operational
30–60 hours
15–30 hours
7–15 hours
3–7 hours
Page 5 of 8
To Maintain
Charge
N/A
N/A
8 hours per day
4 hours per day
2 hours per day
1 hour per day
Echoflex
Advertisement
