Advertisement
Echoflex Installation Guide
Photo & CCT Sensors
Integrated Magnets
Attach the sensor directly to the suspended ceiling T-bar frame using the
two integrated magnets.
Adhesive
Use double-sided tape or Velcro (not provided). Cut a piece of double-
sided adhesive tape or adhesive-backed Velcro to the appropriate length
and press firmly in place.
Link to a Controller
The compatible target controller must be installed, powered, and within
range of the TAP-31 TAP-41.
Note:
controller and to unlink a linked device from a controller.
1. Use your fingers to remove the sensor's flexible cover and access the
[Teach] button. If you have difficulty, consider inserting a small
flatblade screwdriver under one of the release tabs.
2. Press the [Learn] button on the
controller to activate Link mode. If
necessary, refer to the controller
product documentation.
3. Press the [Teach] button on the
sensor once to send a link message.
An LED blinks to confirm a
successful transmission.
4. Deactivate Link mode on the
controller before attempting to link
to any other controllers.
Battery Power
A CR1632 battery is not required for normal operation if the sensor
receives adequate natural or artificial light. See the table in the
Level Test on
installation tests or when the artificial light is insufficient to power the
sensor.
To install the battery:
1. Use your fingers to remove the sensor's cover, flexing it gently to
release the tabs that hold it in place. If you have difficulty, try
inserting a small flatblade screwdriver under one of the release tabs.
2. Insert a new battery in the holder with the + positive side facing up
and press in place.
3. Replace the sensor cover.
Photo & CCT Sensors
The linking process can be used both to link a device to a
page 5. A battery (not provided) may be required to run
Battery holder
Page 3 of 8
Teach button
Light
Echoflex
Advertisement
