Table of Contents
Advertisement
1. Using a small screwdriver for leverage, insert under the clear plastic lens at
one of the relief tabs in the base plate and pull up. You will need to repeat
with at least two tabs until the lens pops free.
2. Using a finger, remove the old battery by pulling the battery free from the
holder. Do not use a screwdriver.
3. Insert the new battery and press in place with your finger.
4. Replace the lens over the sensor aligning the button hole with the teach
button and press in place.
Test Operating Modes
The following tests can be selected when in test mode:
• Light Level Test
• Range Confirmation Test
• Walk Test Mode,
• Sensitivity Adjust Mode
Light Level Test: This test provides visual feedback of the immediate energy
produced by the solar panels.
1. To enter Light Level Test mode, press and hold the teach button until the
green LED begins to blink (about 6 seconds - LEDs are located on right hand
side of the solar panel).
2. Press and hold the teach button again until the green LED stops blinking,
about 6 seconds. The green LED will start blinking faster in accordance to
the light level it is detecting, see table below.
Blinks Lux / Foot candles Time to Fully Charge Discharge Time
0
1
2
3
4
5
The time to fully charge is based on the storage capacitor charging from a
non-operational condition. Discharge time indicates how long a fully charged
sensor will operate in the dark. The test will repeat every 2 seconds and run for
a duration of 100 seconds. You may quit the test at any time by pressing the Test
button for 6 seconds.
Range Confirmation Test: This test provides visual feedback of the sensors
signal strength by a linked receiver with range confirmation capability.
1. To enter Range Confirmation Test mode, press and hold the teach button
until the green LED begins to blink (about 6 seconds).
2. A quick press and release of the button at this point will allow you to select
between test modes. Pressing and releasing the test button scrolls through
the LED indicators. When the amber LED is blinking, go to step 3.
3. Press and hold the test button again for 6 seconds to select Range
Confirmation Test.
Light Level Test Indication
0 / 0
20-40 / 2-4
40-80 / 4-8
80-160 / 8-16
160-320 / 16-32
320 + / 32+
below operating level
operational
48 hours
24 hours
12 hours
6 hours
n/a
n/a
100 hours
150 hours
200 hours
225 hours
5
Advertisement
Table of Contents
