Table of Contents
Advertisement
Enabled Timer. Disabling both the Sensor Occupancy Timer and Audio
Sensitivity setting will have the sensor behave exactly like the IR model.
6. To save the Sensor setting, press and hold the teach button until all the
LEDs double blink. The unit will now be in normal operating mode with the
new setting in effect.
Walk-Test Mode
Walk-test mode allows the installer to verify areas that are within range of the
motion sensor. The faceplate must be removed to allow access to the teach
button.
1. To enter walk-test mode, press and hold the teach button until all the LEDs
blink simultaneously (about 5 seconds).
2. A quick press of the button at this level will allow you to scroll between the
test/setting modes. When the red LED is blinking, go to step 3.
3. Press and hold the button again until the LED stops blinking to select this
mode, about 5 seconds.
The red LED will blink every time a PIR motion sensor trigger is detected and
green for audio triggers. The test times out in 20 minutes. If a faster exit from
walk-test mode is required, press any rocker button or press and hold the teach
button for 10 seconds.
LED Indication
During normal operation, the red LED will blink when the sensor transmits
status after detecting occupancy. This operation allows the user to turn off
the indicator LED. The faceplate must be removed to allow access to the teach
button.
NOTE: New settings do not take affect until you save and exit.
1. To enter LED indication mode, press and hold the teach button until all the
LEDs blink simultaneously (about 5 seconds).
2. A quick press of the button at this level will allow you to scroll between the
test/setting modes. When the green and red LEDs are blinking, go to step 3.
3. Press and hold the button again for 5 seconds to select LEDs On/OFF.
4. A quick press and release of the button at this level toggles between
Double Green (LED ON) and Double Red (LED OFF) - When the desired
state is displayed, press and hold the button for approximately 5 seconds
to save and exit to normal operating mode.
Wireless System Layout Hints
Avoid locating transmitters and receivers on the same wall.
Avoid locating transmitters and receivers where the telegrams must penetrate
walls at acute angles. This increases the material the telegram must pass
through reducing the signal power.
Avoid large metal obstructions as they create radio shadows. Place receivers
in alternate locations to avoid the shadow or use repeaters to go around
the obstacle.
7
Advertisement
Table of Contents
