Table of Contents
Advertisement
To assemble the freezer parts, refer to the following steps:
A. Assemble all O-rings onto parts dry, without lubri-
cation. Then apply a thin film of sanitary lubrication to
exposed surfaces of the O-rings. Also apply a thin
film of sanitary lubricant inside and outside of the
front auger support bushing.
B Assemble the rear seal onto the auger with the large
end to the rear. Be sure the O-ring is in place before
installing the rear seal.
C. Lubricate the auger drive (rear) with a small amount of
white socket lubricant. A container of socket lubri-
cant is shipped with the freezer.
Figure 18. Exploded View of Auger
(Front Door and Related Parts)
CAUTION
Do not place Mix Inlet Regulator into hopper be-
fore installing Auger Shaft assembly. Mix Inlet
Regulator may be damaged by Auger Shaft dur-
ing installation.
D. Install the two plastic flights onto the auger and
insert into freezer barrel.
E. Rotate slowly until the auger engages the drive shaft.
F. Install the auger support bushing into the front door.
G Install the spigot body with O-rings into the front
door from bottom. Push straight up until the spigot is
in place.
H. Install the front door on the freezer.
CAUTION
Overtightening or uneven tightening of circular
freezer door knobs may cause damage to door
and void any factory warranties. Tighten circu-
lar door knobs evenly. Do not overtighten knobs.
I.
Install the circular knobs on the freezer studs and
tighten hand tight.
Look for the proper seal between the freezer barrel, O-ring,
and front door.
Figure 19. Mix Inlet Regulator
J.
Install the mix inlet regulator into the freezer with the
air tube to the front of the freezer (Fig. 19).
K. Install hopper cover and drain tray and drip tray with
insert.
3.12 ROUTINE CLEANING
To remove spilled or dried mix from the freezer exterior,
simply wash in the direction of the finish with warm soapy
water and wipe dry. Do not use highly abrasive materials
as they will mar the finish.
13
Advertisement
Table of Contents
