Extron electronics RGB 302 User Manual page 35

im Vertrieb von
Installing Windows® Control Software
This chapter is dedicated to using Extron's "Windows
Control Program for RGB 302/304 via RS-232"
software. Extron supplies this software that runs in the
Windows® operating system, version 3.1 or later.
Communication between the computer software and
the RGB 302/304 is established after connecting the
computer to the RS-232 Port on the rear panel of the
RGB 302/304 (see diagrams below).
1. Connect the PC's Comm port to the RS-232
2. Power up the RGB 302/304, the PC, and load
3. To install the software from the 3.5" floppy disk onto
___ The floppy disk has instructions printed on the label.
The software can be run from the floppy drive or loaded
onto the hard drive.
www.camboard.de
Page 4-1
CAMBOARD Electronics
Chapter 4 • Using the Windows® Control Program
connector on the back of the RGB 302/304.
Windows.
the hard disk, run SETUP.EXE from the floppy disk.
(It's just like any other Windows application.)
RGB 302
-2 32
RS
L
/EC
MB C AL OG T
AN IN PU
W ER
PO
D IO
A U
R
V
IN
L
V
U T H /H
T P T
O U OU
B
G
0.5 A
24 0V
10 0- R
Hz
50 /60
RGB 304
-2 32
RS
D IO
A U
R
V
L
U T H /H V
T P T
O U OU
B
G
A
0.5
24 0V R
10 0-
Hz
50 /60
Tel. 07131 911201 ce-info@camboard.de
Extron RGB 302/304 Universal Interface • User's Manual
Fax 07131 911203