Removing The Seat; Mounting The Seat - Husqvarna Vitpilen 401 EU 2022 Owner's Manual

12.6

Removing the seat

12.7

Mounting the seat

SERVICE WORK ON THE CHASSIS 12
Main work
–
Push dust boots
Info
The dust boots remove dust and coarse dirt parti-
cles from the inside fork tubes. Over time, dirt can
accumulate behind the dust boots. If this dirt is not
removed, the oil seals behind can start to leak.
F02716-10
Warning
Danger of accidents Oil or grease on the brake
discs reduces the braking effect.
–
Always keep the brake discs free of oil and
grease.
–
Clean the brake discs with brake cleaner when
necessary.
–
Clean and oil the dust boots and inside fork tubes of both
fork legs.
Universal oil spray (
–
Press the dust boots back into the installation position.
–
Remove the excess oil.
Finishing work
–
Take the motorcycle off the front lifting gear. (
–
Remove the rear of the motorcycle from the lifting gear.
( p. 52)
–
Insert the ignition key in seat lock
–
Raise the rear of the seat, pull the seat back, and lift it off.
–
Remove the ignition key.
H02672-10
–
Hook holding lug
rear and push it forward.
–
Insert locking pin
the rear of the seat until the locking pin engages with a click.
–
Check that the seat is correctly mounted.
H02673-10
1
of both fork legs downward.
p. 130)
1
and turn it clockwise.
1
of the seat onto the fuel tank, lower the
2
into the lock housing and push down
p. 54)
55