Intake Side Panel Removal; Customer Connections And Loose Parts; Rear Connections - Generac Power Systems EcoGen 15kW Installation Manuallines

Intake Side Panel Removal

See Figure 2-6. The intake side panel (A) must be
removed to access battery compartment, fuel regulator,
and sediment trap.
1. Raise lid and remove front panel.
2. Use a hex key to remove two mounting screws (B)
and the hex screw on the L-bracket.
3. Lift intake panel up and away from generator.
4. Inspect for any hidden freight damage. Contact
freight carrier if damage is present.
NOTE: Always lift intake side panel straight up before
pulling away from enclosure. Do not pull panel away from
enclosure before lifting up (D).
Figure 2-6. Intake Side Panel Removal
Installation Guidelines For 60 Hz EcoGen™ Generators
Customer Connections and Loose
Parts
See Figure 2-7
and loose parts location.
shipped loose.
E
C
D
B
A Customer electrical connection area (behind access
panel)
A
B Fuel regulator with sediment trap
C Battery compartment (battery not supplied)
D Positive (+) and negative (-) battery cables
E Location of "Loose Shipped Parts"
C
Figure 2-7. Customer Connection Area and Loose

Rear Connections

D
E
002961
A Wi-Fi module
B Main AC/Control wiring hole for 1-1/4 in conduit
C Main AC/Control wiring hole for 3/4 in conduit
D Fuel connection hole
E Auxiliary shutdown switch
NOTE: The generator is equipped with a Wi-Fi module.
See Wi-Fi module owner's manual for further instruction.
Unpacking and Inspection
and Figure 2-8 for customer connections
Figure 2-10
Parts Location
Figure 2-8. Rear Connections
illustrates parts
A
B
001800
A
B
C
D
001360
9