Table of Contents
Advertisement
The Reliable
Ones
SEIO
Portable
Generator
Owner's Manual
A
A
DANGER[
This generator is designed for outdoor use only, Never use this generator inside any building
or enclosure including the generator compartment of a recreational vehicle (RV). Carbon monoxide
poisoning,
fire and/or an explosion
may result. No user performed modifications, including venting of
exhaust and/or cooling ventilation, will eliminate the danger, Always have at least two feet of clearance on
all sides of the generator even while operating the unit outdoors.
DANGER[
You must isolate the generator from the electric utility by opening the electrical system's
main circuit breaker or main switch if this unit is used for backup power, Failure to isolate the generator
from the power utility may result in injury or death to electric utility workers and damage to the
generator due to a backfeed of electrical energy
The Emission Control System for this generator is warranted for standards set by the
Environmental Protection Agency. For warranty information refer to the engine Owner's manual.
Model No 1339-0
(10000 Watt AC Generator)
Manual No. B4472
Revision 2 (8/17/1999)
Visit our Generac website: www.generac-portables.com
This is the safety alert symbol. It is used to alert you to potential personal injury hazards.
Obey all safety messages that follow this symbol to avoid possible injury or death.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Generac Power Systems SE10000
Summary of Contents for Generac Power Systems SE10000
- Page 1 Manual No. B4472 Revision 2 (8/17/1999) Visit our Generac website: www.generac-portables.com This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death.
-
Page 2: Safety Rules
Every effort has been expended to make sure that the information in this manual is both accurate and current. However, Generac reserves the right to change, alter or otherwise improve the product at any time without prior notice. -
Page 3: Grounding The Generator
Generac Portable Products S E10000 G enerator GROUNDING • The generator produces a very powerful voltage that can cause serious injury or death by electrocution. GENERATOR Never touch bare wires or receptacles. Never permit a child or any unqualified person to operate the The National Electric Code requires the frame and generator. -
Page 4: Carton Contents
Generac Portable Products S E10000 Generator Yourgenerator requires someassembly a ndis ready CHECK BATTERY / ATTACH foruseafterit hasbeenproperly serviced withthe NEGATIVE BATTERY WIRE recommended oilandfuel. If you have any problems with the assembly The battery on the generator is fully charged, sealed... -
Page 5: Wheel Kit Installation
Generac Portable Products S E10000 G enerator WHEEL KIT INSTALLATION You will need a 13mm metric box, open end or socket wrench to install this kit. Install other wheel in the same manner. Install Wheel Kit as follows: (Figure 3) -
Page 6: Know Your Generator
Generac Portable Products S E10000 Generator KNOW YOUR GENERATOR Read this owner's manual and safety rules before operating your generator. Compare the illustrations with your generator to familiarize yourself with the locations of various controls and adjustments Save this manual for future reference... -
Page 7: Before Starting The Generator
Generac Portable Products S E10000 G enerator BEFORE STARTING THE can attract moisture, which leads to separation and formation of acids during storage. Acidic gas can GENERATOR damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. -
Page 8: Stopping The Engine
Generac Portable Products S E10000 Generator IMPORTANT! Do not overload the generator! Do DANGER! Engine exhaust contains carbon not overload individual panel receptacles! These monoxide, a colorless and odorless gas which causes unconsciousness and death. Never outlets are protected against overload with push-to- reset-type circuit breakers. - Page 9 Generac Portable Products S E10000 G enerator 120 Volt AC, 20 Amp Receptacle Connecting Electrical Loads • DO NOT connect 240 Volt loads to 120 Volt Use a NEMA L5-20 plug with this receptacle Connect receptacles a 3-wire cord set rated for 125 Volts AC at 20 Amps (or greater) to the plug (Figure 9).
- Page 10 Generac Portable Products S E10000 Generator Usethisreceptacle t o operate 120VoltAC,60 Hz, 240 Volt AC, 50 Amp Receptacle singlephase loadsrequiring upto 3600watts Use a NEMA 14-50 plug with this receptacle. (3.6kW)ofpower at 30Amps.Theoutlet i s protected Connect a 4-wire cord set rated for 250 Volts at bya 30Amppush-to-reset circuit b reaker.
-
Page 11: Don't Overload The Generator
Generac Portable Products S E10000 G enerator DON'T OVERLOAD • If wattage is not given, multiply volts times ampere rating to determine watts (volts x amps = watts). GENERATOR • Some electric motors, such as induction types, require about three times more watts of power for Overloading a generator in excess of its rated wattage starting than for running. -
Page 12: Specifications
Generac Portable P roducts S E10000 Generator GENERAL MAINTENANCE more than 30 days, use the following guidelines to prepare it for storage. RECOMMENDATIONS Generator Storage The Owner/Operator is responsible for making sure • Clean the generator as outlined in "To Clean the that alt periodic maintenance tasks are completed on Generator."... - Page 13 Generac Portable Products S EIO000 G enerator NOTES...
-
Page 14: Troubleshooting
Generac Portable Products S E10000 Generator TROUBLESHOOTING Problem Cause Solution 1. Reset circuit breaker, Engine is running, but no AC 1. Circuit breaker is open. output is available. 2. Poor connection or defective cord 2. Check and repair. set. 3. Connected device is bad. - Page 15 Generac Portable Products S EIO000 G enerator NOTES...
- Page 16 Generac Portable Products S EIO000 Generator ID]_LF_i_]_ SCHEMATIC DIAGRAM EXCITATION CAPACITDR 44&...
-
Page 17: Wiring Diagram
Generac Portable Products S EIO000 G enerator ID_'! WIRING DIAGRAM ¢5_ SWITCH TERMINAL _LDCK CaNTRaL PANEL GRDUND REAR BEARING CARR[ER SUPPLrE_ _ATTERY... -
Page 18: Generator Exploded View
Generac Portable Products SEIO000 Generator ?j/- GENERATOR EXPLODED VIEW 7"\\\\\ Detail Battery Troy \\_20... -
Page 19: Parts List
Generac Portable Products S E10000 G enerator GENERATOR PARTS LIST Item Pa_ # Description Item Pa_ # Description B4627 ENGINE, Robin 18HP KEY, Ignition Switch BB4509 SHIELD, Heat AB4682 BRACKET, Ignition Switch A77304 A96925 SUPPORT, Engine BRACKET, Battery Tie Down... - Page 20 Generac Portable Products SE10000 Generator ALTERNATOR EXPLODED VIEW AND PARTS LIST \\\\\ Item Part # Description Item Part # Description B4906 SHIELD, Front B4915 BEARING, 62052RS C3 B4907 GRID, Front B4916 CAPACITOR, Diode + Varistor B4908 + EMC BOLT, Shaft Stay...
- Page 21 Generac Portable Products S E10000 G enerator CONTROL PANEL EXPLODED VIEW AND PARTS LIST Item Pa_ # Item Pa_ # Description Description BB4504 43437 PANEL, Control OUTLET, 120/240V, 30 Amp 23897 FLAT WASHER, #10 - M5 Locking 91526 PPHMS, M5- ,08 x 12mm...
- Page 22 Generac Portable Products SE10000 Generator ? j/_ WHEEL KIT EXPLODED VIEW AND PARTS LIST Item Pa_ # Description HANDLE 93393B 39287 HHCS, M8 - 125 x 45mm 52858 NUT, Locking M8 - 1 25 93394 LEG, Mounting Support 27007 MOUNT, Vibration...
- Page 23 Generac Portable Products S EIO000 G enerator NOTES...
-
Page 24: Limited Warranty
PORTABLE GENERATORS GENERAC PORTABLE PRODUCTS (hereafter referred to as the COMPANY) warrants to the original purchaser that all components originally equipped with the generator, excluding the engine, for its portable generator will be free from defects in materials or workmanship for the items and period set forth below from the date of original purchase.
Need help?
Do you have a question about the SE10000 and is the answer not in the manual?
Questions and answers