Husqvarna DM 230 Operator's Manual page 9

Technical data on page 20 for
fault occurs. Refer to
information about at which current the PRCD engages.
The red light shows that the PRCD is on and that the
product can be started. If the red light does not show,
push the RESET button.
To examine the PRCD
WARNING:
type sold in United Kingdom and Ireland.
PRCD on page 8 .
Refer to
WARNING:
examined each time the power plug is
connected to a power outlet.
WARNING:
repaired, always speak to an approved
Husqvarna service agent.
1. Connect the power plug of the product to a power
outlet.
2. Push the "RESET" button. The indicator above the
button is red when the current is connected.
3. Start the product, refer to
page 13 .
4. Push the "TEST" button. If the product stops, the
PRCD operates correctly.
1473 - 001 - 04.04.2022
Not applicable for 110V
The PRCD must be
If the PRCD must be
To start the product on
Power switch
The power switch is used to start and stop the product.
To do a check of the power switch
1. Connect the power plug of the product to a power
outlet.
2. Push the power switch to start the product.
3. Release the power switch to stop the product.
Safety instructions for maintenance
WARNING:
maintenance should be carried out with
Inspection and/or
9