Husqvarna DM 230 Operator's Manual page 14

WARNING:
started on the work day, do a check of the
PRCD. Refer to
page 9 .
1. Connect the power plug of the product to a power
outlet.
2. Push the "RESET" button on the PRCD.
3. To set the operation speed, turn the drill spindle and
at the same time move the gear selector. Set the
gear selector in the correct position for the operation.
4. For wet drilling, connect the water system and open
the water system. Refer to
for wet drilling on page 11 .
5. For dry drilling, attach the dust extractor to the
product and start the dust extractor. Refer to
prepare the product for dry drilling on page 11 .
14
The first time the product is
To examine the PRCD on
To prepare the product
To
6. Push and hold the power switch.
To drill a start hole with the
™
Smartstart function
™
The Smartstart function decreases the speed of the
motor. This helps to make a start hole. The decreased
™
speed of the Smartstart
start holes and not for usual operation.
1. Start the motor. Make sure that the drill bit does not
touch the material.
2. Push the Smartstart
speed decreases and the Smartstart
A
3. Drill a start hole in the material.
Note:
The Smartstart
automatically when the speed increases.
4. To stop the Smartstart
™
Smartstart function button again.
To operate the product
WARNING:
remove the drill bit from the hole before you
push "RESET".
function is only applicable for
™
button (A) one time. The
™
function is on.
™
function goes off
™
function manually, push the
If the PRCD engages,
1473 - 001 - 04.04.2022