Transportation And Storage - Husqvarna DM 230 Operator's Manual

Hide thumbs Also See for DM 230:
Table of Contents

Advertisement

Available languages

Available languages

Problem
The product does not con-
tinue into the surface, de-
creases in speed and stops.
Unwanted material collects
around the hole during oper-
ation.
The diamond segments on
the drill bit are pulled out of
their bond.
There is a leakage of gear
oil.
There is a leakage of water
from the hole on the water
connection ring.
The product does not oper-
ate smoothly.
Pull out the plug from the power outlet before
transportation or storage of the product.
Remove the drill bit before transportation or storage
of the product. This is to prevent damage to the
product and the drill bits.
Keep the product in a locked area to prevent access
for children or persons that are not approved.
Keep the product in a dry and frost-free area.
Safely attach the product during transportation to
prevent damage and accidents.
1473 - 001 - 04.04.2022
Steps to do im-
Possible cause
mediately
The diamond segments are
blunt.
The water pressure is too
low.
Release the
There are much vibration in
power switch.
the product during the oper-
ation.
The seals are worn out and
must be replaced.
The shaft seals are defect.
Decrease the
Too high load causes over-
force.
load of the motor.

Transportation and storage

Solution
Sharpen the diamond segments
with a SiC grind stone.
Increase the water pressure. Refer
Technical data on page 20 .
to
Use correct load when you operate
the product.
Speak to an approved Husqvarna
service center.
Speak to an approved Husqvarna
service center. Make sure to always
use clean water.
Use less force when you drill.
19

Advertisement

Table of Contents
loading

Table of Contents