IBEX TS51C Assembly Manual page 13

ASSEMBLY GUIDE
Figure 18 holes aligned to allow pin to pass
Drive the pin through. Fit the washer and the nut. The nut takes a 30mm wrench. Do not over-
tighten, just snug. Insert a screwdriver or similar tool in the hole of the pin to keep the pin
from turning, as shown in Figure 19.
Figure 19 using a screwdriver to keep the pin from turning while securing the nut
To install the top spring arm, support the lower arm as shown in Figure 20 with a 2 foot length
of 2x4 or a floor jack. Doing this will prevent the pivot pin from falling out of the sleeve when
the cap removed. Attach the top spring arm around the cap as shown in Figure 20 and secure
the nut and bolt. Again, do not over-tighten as it needs to be able to pivot.
2022-1.0 IBEX EQUIPMENT CO. 12