IBEX TS51C Assembly Manual page 12

ASSEMBLY GUIDE
Next get the shorter of the two swivel pins as seen in Figure 16. It usually has the washer and
nut attached.
Figure 16 short swivel pin
Align the two holes on the support arm shown in Figure 17 so that they are centered on the
bottom of the swivel tee. If the holes are not well aligned, the pin will not go through and the
bushings could be damaged. You can use an adjustable-height stand to hold up the arm while
aligning the holes (we used a chair). Take note of the orientation of features so that it is
installed right-side up.
Figure 17 align holes in arm to swivel tee
Adjust the centers of the holes to be concentric and well-aligned before attempting to push
the pin through.
2022-1.0 IBEX EQUIPMENT CO. 11