IBEX TS51C Assembly Manual page 11

ASSEMBLY GUIDE
Figure 14 the cap and hardware are shown here for the swivel tee
Install the swivel tee into the side sleeve of the 3 point hitch as shown in Figure 15. Insert the
bolt and thread the nut until you feel some resistance, so that the nut doesn't unthread during
the remainder of assembly. Don't tighten any more all the way as the bolt will need to come
back out to mount the top arm later. The nut requires a 30mm wrench.
Figure 15 swivel tee in place for next step
2022-1.0 IBEX EQUIPMENT CO. 10