Actuator Motor; Cam Arm; [A] Cam Arm (A) - Actuator Motor Side; [B] Cam Arm (B) - Rear Side - Hoshizaki IM-240DNE Service Manual

11. ACTUATOR MOTOR

1) Remove the top panel and front panel.
2) Push the reset switch on the control box to open the water pan.
3) Unplug the icemaker or disconnect the power source.
4) Remove the extension spring (actuator motor side) from the cam arm.
5) Disconnect the actuator motor leads in the wiring channel.
6) Remove the actuator motor bracket.
7) Remove the spring pin securing the shaft to the cam arm.
8) Remove the actuator motor.
9) Install the new actuator motor in the reverse order of the removal procedure.
10) Check that the cam arm can move in the proper range.
11) Replace the panels in their correct positions.
12) Plug in the icemaker or connect the power source.

12. CAM ARM

[a] CAM ARM (A) - ACTUATOR MOTOR SIDE

Refer to "11. ACTUATOR MOTOR".

[b] CAM ARM (B) - REAR SIDE

1) Remove the top panel and front panel.
2) Push the reset switch on the control box to open the water pan.
3) Unplug the icemaker or disconnect the power source.
4) Remove the extension spring from the cam arm (B).
5) Remove the split pin from the cam shaft.
6) Remove the cam arm (B).
62