Actuator Motor - Hoshizaki IM-21CNE Service Manual

11. ACTUATOR MOTOR

1) Remove the top panel and front panel.
2) Push the reset switch on the control box to open the water pan.
3) Unplug the icemaker or disconnect the power source.
4) Remove the extension spring (actuator motor side) from the cam.
5) Disconnect the actuator motor leads in the wiring channel.
6) Remove the actuator motor bracket.
7) Remove the spring pin securing the shaft to the cam.
8) Remove the actuator motor.
9) Install the new actuator motor in the reverse order of the removal procedure.
10) Check that the cam can move in the proper range.
11) Replace the panels in their correct positions.
12) Plug in the icemaker or connect the power source.
1 Actuator Motor
2 Cam (A)
3 Spring Pin
4 Spring
5 Actuator Motor Bracket
6 Truss Head Machine Screw
7 Flat Head Machine Screw
8 Silicone Tube
9 Silicone Tube
10 Tie
11 Actuator Motor Cover
12 Hex Head Bolt
Fig. 16
78