Singer Confidence 7463 Service Manual page 30

1. Turn off power switch.
2. Loosen one of two screws on motor gear.
3. Turn on power switch and set machine at test mode 2 [Zero feed] and motor shaft will be
held at one of exciting position.
4. Loosen other screw on motor gear for adjustment and motor gear will become free from
motor shaft.
5. Rotate projection (1) of motor gear until it touches with stopper pin and you will get position
for origin point positioning.
6. Temporarily tighten one screw which is located for easier access for adjustment.
7. Set machine at test mode 2 [Zero feed] again by turning on power switch.
8. Activate the origin point positioning of feed motor by turning hand wheel manually.
9. Adjust by moving motor gear in either direction with 1.5 mm hex driver running machine with
a little thick paper placed under presser foot.
Re-checking and re-adjusting feed balance of actual patterns
After checking Feed Zero with needle only, re-check feed balance of actual patterns under following
conditions:.
1. Fabric: Demo swatch
2. Thread: Coats & Clark #60
3. Presser foot: Satin foot
4. Actual patterns to be checked:
7422, 7424, 7442, 7444, 7462 and 7464 –
zigzag stitch with stitch length at 0.25 and smocking stitch
7426, 7446,*7436 and 7466 –
zigzag stitch with stitch length at 0.25 and honeycomb stitch #44 at default position.
Adjust zero feed
by turning this screw.
- 30 -