Golden BUZZ ABOUT GP164 Owner's Manual page 14

Arm Installation
1.Loosen the arm width adjustment screw from the arm receiver tube at the bottom rear
of the seat frame. See figure 5.
2. Insert the arm into the arm receiver tube, so that the arm pad faces toward the front
of the unit.
Arm Width
Adjustment
Screw
3. Adjust the width of the arm.
4. Tighten the arm width adjustment screw to secure the arm in place.
5. Repeat steps 1 – 4 for the opposite side.
Flag Installation
1. Connect the two halves of the flag by sliding them together.
2. Locate the flag holder, which is sewn into the seat pocket on the left-side of the seat
back. See figure 5.
3. Slide the flag down into the sewn flag holder.
Seat Belt Installation (Optional Equipment)
1. Remove the arm width adjustment screw from the arm receiver tube at the bottom
rear of the seat frame. See figure 5.
2. Insert the armrest adjustment screw through one of the seat belt anchors, reinsert the
screw into the receiver tube, and tighten to secure.
3. Repeat steps 1 and 2 for the opposite side of the seat belt.
IV. ASSEMBLY
Flag - Insert Here
Figure 5
14
Arm Width
Adjustment
Screw