Built-In Clock Errors; Fan Errors; Test Value Errors - FujiFilm DRI-CHEM NX10N Instruction Manual

7 Troubleshooting
Error code
E0306 ADC calibration ERR
Faulty controller
Contact your dealer
E0307 ADC conversion ERR
Faulty controller
Contact your dealer
E0308 Unstable W-plate
Contact your dealer
****** [digit]
E0320- Calculation ERR
E0323 Contact your dealer

7.2.4 Built-in clock errors

Error code
E0500
Date ERR
Run Mode 2
Set date & time
7

7.2.5 Fan errors

Error code
E0600
Faulty fan
Contact your dealer

7.2.6 Test value errors

Error code
W0610 No spot or No slide
Rerun the test
W0611
Abnormal high value
Check the sample
OD: *******
7-4
Error message
The circuit board has a
malfunction (signal error).
The fluctuation of light source
intensity is large before and
after performing photometry
on a slide.
T h e c i r c u i t b o a r d h a s a
malfunction (signal error).
Error message
The built-in clock has been
reset.
Error message
The fan has malfunctioned.
Error message
The test may be started
under the following
conditions:
• No slide is set.
• No sample is placed on the
slide.
• A slide was set upside
down.
The test value is abnormally
high.
Error status
Turn the power switch off and on. If
the error still occurs, please contact
your technical support (dealer) for
assistance.
Error status
Set the date and time using the Date
& Time settings of mode function.
(Refer to P8-6)
If the error still occurs, please contact
your technical support (dealer) for
assistance.
NOTE: Turning the power on for the
IMPORTANT:
In case that the date and time
are not adjusted correctly, the
analyzer may fail to determine
the expirations of the slides, so
that the test results may NOT be
accurate.
Error status
Turn the power switch off and on. If
the error still occurs, please contact
your technical support (dealer) for
assistance.
Error status
Rerun the tests.
897N120152H FDC NX10N Instruction Manual 04.2022
Solvent
Solvent
first time may cause the date
error E0500.
Solvent
Solvent