Bush NE-3140 Instruction Manual page 21

Using your DAB/FM Radio
Let's get started
5. The alarm setup prompts you for the following parameters. Select a value for each parameter
by press ▼/▲ buttons, and then press the SELECT button to move on to the next parameter.
6. Parameters
→ On Time –Hours and minutes
→ Duration-15/30/45/60/90 minutes
The alarm will continue ring during the selected period if leave it idle. And it will switch to
standby mode afterward.
→ Source- Buzzer/DAB/FM
If DAB or FM is chosen as the audio source you will also be prompted to select the last
played station or one of the preset station (if set)
→ Daily/Once/Weekends/Weekdays
Choose the days on which the alarm is active
Note: if you choose "Once", you are prompted to enter the require date.
→ Volume – Press the TUN/CH▼ or TUN/CH▲ button to increase or decrease the volume
you desired. This is the volume the alarm will build up to. (Initially the alarm sounds at a
low volume and gradually gets louder to the set volume)
→ Alarm – Off/ On
∞ In standby mode, active alarms are indicated by displaying the relevant Alarm icons.
∞ At the set time, the alarm will sound, quietly at first, then gradually building up to the set
volume.
To turn alarms on or off in standby mode
∞ Press the ALARM/SNOOZE button, the display shows the current alarm status. To switch the
alarms on or off
Press the ALARM/SNOOZE button repeatedly to cycle through four states as shown below (F.11)
∞
To choose the display Alarm status, press the SELECT button to confirm
∞
SNOOZE (AC OPERATION ONLY)
To temporarily silence a sounding alarm, press the ALARM/SNOOZE button once, you can change
the snooze period by repeatedly pressing the ALARM/SNOOZE button, Snooze periods are 5,10,
15 or 30 minutes. The radio returns to standby for the set time period with Snooze countdown
displayed. When the countdown reaches 0(zero) the alarm triggered again. (F.12) (F.13)
21