Advertisement
Imported by Amart Furniture Pty Ltd
For any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Free call 1800 351 084
ASSEMBLY INSTRUCTION
REIMS BEDSIDE
ITEM CODE
73887
Imported by Amart Furniture Pty Ltd, Brisbane Qld, Australia.
For any assistance with assembly or for missing parts please
phone Amart Furniture, Customer Service Free call 1800 351
084
,Brisbane,
Qld, Australia.
1
ITEM CODE 73887
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Amart Furniture REIMS BEDSIDE 73887
Summary of Contents for Amart Furniture REIMS BEDSIDE 73887
- Page 1 ASSEMBLY INSTRUCTION REIMS BEDSIDE ITEM CODE 73887 Imported by Amart Furniture Pty Ltd, Brisbane Qld, Australia. For any assistance with assembly or for missing parts please phone Amart Furniture, Customer Service Free call 1800 351 Imported by Amart Furniture Pty Ltd ,Brisbane, Qld, Australia.
- Page 2 PRE-ASSEMBLY PREPARATION Before you start: 1.Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the product 2.Take care when lifting. Product should be assembled as near as possible to the point of 3.Ensure that you have all required contents for complete assembly 4.Always read the assembly instructions carefully before beginning assembly.
- Page 3 PARTS LIST 1 BEDSIDE BODY 2 FOOT A. BOLT 1/4''X20MM B. FLAT WASHER C. ALLEN KEY D. WALL FIXING ITEM CODE 73887...
- Page 4 • Attach foot (2)to bedside body (1) using flat washers(b) and bolts (a). • Tighten with Allen Key (c). Sides of the leg that have angle must point inward OUTSIDE INSIDE ITEM CODE 73887...
- Page 5 ASSEMBLY IS COMPLETE ITEM CODE 73887...
- Page 6 SAFETY BRACKETS INSTRUCTIONS 1. Attach one Mounting Plate to the wall with the Large Screws. Make sure to attach the Mounting Plate into a stud. If mounting into brick or masonry you will need to acquire wall anchors. 2. Attach the second Mounting Plate to the furniture frame with the Short Screws. 3.
- Page 7 CARE AND MAINTENANCE • A multi-step finish is applied to all our furniture, but all wood comes from nature. Because of this, there will be natural variations in surface texture and grain like knots, mineral streaks and sap runs that may affect the finish.
Need help?
Do you have a question about the REIMS BEDSIDE 73887 and is the answer not in the manual?
Questions and answers