Table of Contents
Advertisement
ATTACHING THE REAR-FOOT MOUNTS
1.
Using a 4 mm hex wrench, remove the two screws from one
shock-frame mounting block (Figure 5).
Set aside the mounting block. Discard the screws.
2.
Using a #1 Phillips screwdriver, remove the two black screws
from the accessory-mounting point on the cot main frame, near
the footrest (Figures 6-7). Discard the screws.
3.
Slide the lip of the rear-foot mount block (Figure 1, page 8)
under the edge of the cot main frame extrusion and align the
two holes in the rear-foot mount block with the accessory-
mounting point holes in the cot main frame (Figure 8).
4.
Using a 3 mm hex wrench and two M5x40 screws, secure the
rear-foot mount to the cot main frame (Figure 8). Fully tighten
the screws.
5.
Repeat Steps 1-4 on the opposite side of the cot.
6.
Verify the cot footrest is in position. If it was removed to install
the PacRac+ mounts, position the footrest with the frame facing
upward as shown in Figure 2, page 8.
7.
Using a 4 mm hex wrench, reattach the two shock-frame
mounting blocks with four new M6x45 pan-head screws
(provided).
© Ferno-Washington, Inc. / 00148-AU-V4 / AUG 2021
Setup
Shock Frame Screw (2)
5
6
7
8
Shock Frame
Mounting Block
Remove Phillips Screws
9
Advertisement
Table of Contents
