Table of Contents
Advertisement
4.2 Attaching the PacRac+ Mounts
To an iN∫X
Attach the PacRac+ mounts (Figure 1 page 8, provided) to the iN∫X
main frame to prepare it for use with the PacRac+. The PacRac+
attaches to the control end (or foot end) of the iN∫X, above the shock
frame (Figure 9).
ATTACHING THE REAR-FOOT MOUNTS
1.
Discard from the kit two front-foot mounts and two M6x25
screws. You will not need them to install the mounting blocks
on an iN∫X.
2.
Using a 3 mm hex wrench, remove the two outer screws from
the accessory mounting point on the iN∫X main frame, near the
footrest, leaving the center of three screws in place (Figure 10).
Discard the two screws that you removed.
3.
Slide the lip of the rear-foot mount block (Figure 1, page 8)
under the edge of the iN∫X main frame extrusion and align
the two holes in the rear-foot mount block with the accessory-
mounting point holes in the iN∫X main frame (Figure 11).
4.
Using a 3 mm hex wrench and two M5x40 screws, secure
the rear-foot mount to the iN∫X main frame (Figure 11). Fully
tighten the screws.
5.
Repeat Steps 2-4 on the opposite side of the iN∫X.
10
Setup
9
Remove Phillips Screw (2x)
10
11
© Ferno-Washington, Inc. / 00148-AU-V4 / AUG 2021
PacRac+Mounts Here
Do Not Remove
Center Screw
Advertisement
Table of Contents
