Setup; Attaching The Pacrac+ Mounts To A Mondial® Monobloc - Ferno PacRac+ FWEPR+ IT User Manual

4.1 Attaching the PacRac+ Mounts to a
Mondial® Monobloc
Attach the PacRac+ mounts (Figure 1, provided) to the cot main
frame to prepare the cot for use with the PacRac+. The PacRac+
attaches to the control end (or foot end) of the cot, above the shock
frame (Figure 2).
KIT COMPONENTS - FWEPR+ IT
Parts Included
Front-foot mount
Rear-foot mount
M6x25 CSK SCS with nylon patch
M5x40 CSK SCS with nylon patch
M6x45 BHCS with nylon patch
Tools Required
3 mm Hex wrench
4 mm Hex wrench
#1 Phillips screwdriver
ATTACHING THE FRONT-FOOT MOUNTS
1. Using a 4 mm hex wrench, remove the screw from the accessory
mounting point on the cot main frame, near the sidearm (Figure
3). Discard this screw.
2. Orient the funnel of the front-foot mount upward and insert an
M6x25 screw (provided) with the head of the screw inside the
funnel.
3. Using a 4 mm hex wrench, attach the front-foot mount to the
cot main frame (Figure 4). Fully tighten the screw.
4. Repeat Steps 1-3 on the opposite side of the cot.
8

Setup

4 - SETUP
Rear-Foot Mount (2)
Qty.
and M5x40 CSK SCS (4)
2 ea.
1
2 ea.
2 ea.
4 ea.
4 ea.
Qty.
1 ea.
1 ea.
1 ea.
2
3
4
Lip
PacRac+Mounts Here
© Ferno-Washington, Inc. / 00148-AU-V4 / AUG 2021
Front-Foot Mount (2)
and M6x25 CSK SCS (2)
M6x45 BHCS for
Shock Frame (4)