Introduction And Intended Use; Safety Information; Warnings - CUMMINS ALLISON CMX01 User Manual

Table of Contents

Advertisement

Introduction and Intended Use

The CMX01 is a high-speed counter for coins and tokens. It is designed to count a very wide range of coin sizes.
The pre-selected coin size will be counted while smaller coins are being rejected without slowing down the
counting speed. The count result can accumulate in value or pieces. Besides variable bag stops and count
memory the CMX01 offers many useful features to meet your requirements.
The general usage of the CMX01 is to process coins or tokens in the specified dimensions. Only use the coin
counter in accordance with the instructions in this manual. The supplier is not responsible for any damage
occurred by improper usage.
This manual gives the user detailed information about the usage of the machine and must be read before using
the CMX01.

Safety Information

Always follow basic safety precautions when using this product to reduce risk of injury from fire or electric
shock. Observe all warnings and instructions marked on the product.
Do not install or use this device outdoors, near water, or when you are wet. Install the product securely on a
stable surface. See also chapter "Installation" Never exceed the specified load of the bags as itemized in this
manual. Failure to do so, may result in damage and or user injury.
Do not touch the coin disc when it is in operation. Use best practice Take extra care of long hairs or loose
clothing (e.g., tie). If it is caught in the machine, switch off the power immediately.
Ensure to Unplug the CMX01 from wall outlets before cleaning.
Do not clean the machine with any chemical cleaners and do not use compressed air, as damage to the
machine and or parts may occur.
If the product does not operate as normal, see the chapter for "Troubleshooting".
Do not operate the machine when covers are removed.
Servicing must be carried out by qualified service personnel only.

Warnings

On the machine and in this manual standardized warning symbols are used. There meanings are as follows:
Warning
Electrical danger
Risk of tilting
Warning of possible danger, such as moving parts.
Warning of possible injuries through electrical shocks
Warning of possible device tilting. Do not exceed the weight of 9 kg in
the counting bag and 7 kg in the reject bag.
(See also Chapter "Installation")
CUMMINS ALLISON, A CPI BRAND 3350 Ridgeway Drive, Unit 3, Mississauga, Ontario L5L 5Z9
www.cranepi.com Tel: 1-800-499-6191
3

Advertisement

Table of Contents
loading

Table of Contents